Craftbeerpi problem

[Kayaba]

Witam mam następujący problem 

 

Would you like run apt-get update & apt-get upgrade? (y/n): y
Hit:1 http://raspbian.raspberrypi.org/raspbian buster InRelease                
Hit:2 http://archive.raspberrypi.org/debian buster InRelease                   
Reading package lists... Done
Reading package lists... Done
Building dependency tree       
Reading state information... Done
Calculating upgrade... Done
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
Would you like to install wiringPI? This is required to control the GPIO (y/n): y
Cloning into 'wiringPi'...
fatal: unable to connect to git.drogon.net:
git.drogon.net[0: 188.246.205.22]: errno=Connection refused
git.drogon.net[1: 2a03:9800:10:7b::2]: errno=Network is unreachable

./install.sh: line 43: cd: wiringPi: No such file or directory
./install.sh: line 44: ./build: No such file or directory
Reading package lists... Done
Building dependency tree       
Reading state information... Done
python-setuptools is already the newest version (40.8.0-1).
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
./install.sh: line 54: easy_install: command not found
Reading package lists... Done
Building dependency tree       
Reading state information... Done
python-dev is already the newest version (2.7.16-1).
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
Reading package lists... Done
Building dependency tree       
Reading state information... Done
libpcre3-dev is already the newest version (2:8.39-12).
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
Could not open requirements file: [Errno 2] No such file or directory: 'requirements.txt'

Would you like Gembird USB Support (y/n): y
Reading package lists... Done
Building dependency tree       
Reading state information... Done
sispmctl is already the newest version (3.1-1).
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
Would you like to start CarftBeerPI automatically after boot? (y/n): y
sed: can't read config/craftbeerpiboot: No such file or directory

 

Co mogę zrobić aby to naprawić ?
 

[Eselchen]

Would you like to install wiringPI? This is required to control the GPIO (y/n): n

 

powinno wszystko działać